7mÊÓƵ

®             
® LISTED WIRE CONNECTOR


TYPES YA-A and YS-A
90°C, up to 35 kV

RECOMMENDED FOR USE ON COPPER AND ALUMINUM CONDUCTOR

INSTALLATION INSTRUCTIONS:

1		Use a HYLUG™ terminal or HYLINK™ splice marked for the wire size to be used.  Never use a copper crimp connector on aluminum wire.
2		Strip the wire insulation without nicking or ringing the conductor strands
3		Always wire brush the stripped portion of the conductor to remove oxide film.
4		Insert the conductor all the way into the barrel and crimp the connector using a die index number and color marked on the connector. Be sure orientation is correct before crimping.
5		Wire brush any unplated surface to which the HYLUG™ will be attached and coat the contact surface with PENETROX™ joint compound  Remove any excess PENETROX™ before taping.

Dieless tools and nest/indenter tools will have a completed crimp similar to illustration shown BELOW:

Other die sets listed have a completed crimp of a more circumferential nature and will look similar to this illustration:

BURNDY^®

^{Aluminum HYLUG™ Terminal and HYLINK™ Splice Connectors}

① Catalog # PUADP-1 Adaptor is required to use U dies in Y46 series tools
② Catalog # PT6515 Adaptor is required to use U dies in Y45 series tools
③ CCA DLO Conductor to be installed with Y644/PAT644 series of tools only